How To Make A Bootable Usb Using CMD in Window 7

How To Make A Bootable Usb For Window 7 Just Simple Setups
Open cmd.
and type DISKPART and press Enter.
Then type LIST DISK and press Enter.
3. You will see a listing of the disk
drives connected to your computer.
Find the disk number of your USB
drive and type SELECT DISK [USB disk #] ,
where "[USB disk #]" is the disk # for
your USB drive. It should now state
that your USB drive is the selected
disk. If you're not sure what disk is
the USB disk, eject the USB drive,
perform step number 2 again, connect
the USB drive again, and compare the
results. Usually the USB drive will be
the last drive.
4. Type in the following commands,
one by one, pressing Enter after each
command.
CLEAN
CREATE PARTITION PRIMARY
SELECT PARTITION 1
ACTIVE
FORMAT FS=NTFS
(may take a couple minutes,
depending on the USB drive size)
ASSIGN
EXIT
Keep the command prompt window
open, but you can minimize it for a
little bit.
5. You will now need your Windows
Vista or 7 Installation DVD. Put the
DVD in your computer's DVD drive.
Open up My Computer and note which
drive letter is assigned to your DVD
Drive and your USB flash drive.
6. Go back to the command prompt
window and type in D: CD BOOT
(substitute your DVD drive letter for
"D:" if necessary) and press Enter.
Type CD BOOT again and press Enter.
Lastly, type BOOTSECT.EXE /NT60 H:
(substitute your USB flash drive letter
for "H:" if necessary) and press Enter.
7. The last step is to copy the entire
contents of the Windows DVD to your
USB flash drive.
Your USB flash drive is now set up to
be a bootable USB drive for Windows
Vista or 7.
Yah window 7 ki cmd main bootable ho gei